Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE CONTROLS
The refrigerator
control functions as the thermostat
for the
entire appliance
(refrigerator
and freezer sections). The
colder the setting, the longer the compressor
will run to
keep the temperature
colder. The freezer control adjusts
the cold air flow from the freezer to the refrigerator.
Setting the freezer control to a lower temperature
keeps
more cold air in the freezer compartment
to make it
colder.
AIRFLOW
Cold air circulates
from the freezer to the fresh food
section and back again through air vents in the wall
dividing
the two sections. Be sure not to block vents while
packing
your refrigerator.
Doing so will restrict airflow
and may cause the refrigerator
temperature
to become
too warm or cause interior moisture buildup. (See air flow
diagram
below.)
Temperature Mode Switch Function (°F <->°C)
If you want to convert °F to °C or vice versa, press and
hold the Freezer Temp and Refrigerator
Temp buttons at
the same time for approximately
five seconds.
Articulating Mullion
This feature is a metal strip attached
to the left door
that articulates
(rotates) 90 degrees as the door is
closed, forming
a mullion (base) for the left and right
door gaskets to seal against.
4_, CAUTION
To reduce the risk of scratching
the door or breaking
the
door mullion, make sure that the refrigerator
door mullion
is always folded
in.
Temperature
The Refrigerator Temp. Control ranges from 33°F to
46°F (O°C to 8°C). Pressthe Refrigerator Temp. button
to cycle through the available
temperature
settings one
increment at a time.
The Freezer Temp. Control range is from -6°F to 8°F
(-21°C to -13°C). Pressthe Freezer Temp. button to
cycle through the available
temperature
settings one
increment at a time.
NOTE: When changing
control settings, wait 24 hours
before making additional
adjustments.
The controls are set
correctly
when milk or juice is as cold as you would like
and when ice cream is firm. If the temperature
in either
compartment
is too cold or too warm, change the setting
one increment at a time. Wait 24 hours for the change to
stabilize
before adjusting
again.
Ultra Ice
When you touch the Ultra Ice button, the graphic
will
illuminate
in the display and will continue for 24 hours.
The function
will automatically
shut off after 24 hours.
You can stop this function
manually
by touching
the
button one more time.
This function
increases both ice making and freezing
capabilities.
Door Alarm
When
power is connected
to the refrigerator,
the door
alarm
is initially
set to ON. When you press the Door
Alarm
button, the display will change to OFF and the
Door Alarm
function
will deactivate.
When either the refrigerator
or the freezer door is left
open for more than 60 seconds, the alarm tone will
sound to let you know that the door is open.
When you close the door, the door alarm will stop.
17
Publicidad
