EINHELL GC-KS 18 Li Manual De Instrucciones Originales página 29

9. Notes on environmental
protection / disposal
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should be
taken to a suitable collection center for proper dis-
posal. If you do not know the whereabouts of such
a collection point, you should ask in your local
council offi ces.
11. Troubleshooting
Danger!
Before troubleshooting, switch off the equipment and pull out the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if
your tool fails to work properly. If the problem still persists after working through the list then please con-
tact your nearest service workshop.
Cause
Chainsaw does not
work at all
Chainsaw operates
intermittently
Saw chain dry
Chain brake does
not work
Chain/guide rail hot
Chainsaw judde-
ring, vibrating or not
sawing properly
Anl_GC_KS_18_Li_SPK7.indb 29 Anl_GC_KS_18_Li_SPK7.indb 29
GB
Fault
- Quick stop brake (chain brake) trip-
ped
- No power supply
- Loose connection (external)
- Loose connection (internal)
- ON/OFF switch defective
- No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
- Problem with the switch mecha-
nism in the front hand guard
- No oil in the tank
- Oil tank cap breather blocked
- Oil outlet blocked
- Blunt chain
- Chain tension too loose
- Blunt chain
- Worn chain
- Saw teeth pointing in the wrong
direction
- 29 -
10. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 5 and 30 °C. Store the electric tool
in its original packaging.
Remedy
- Pull the hand protection back to the
normal position.
- Check the power supply.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet.
- Consult a specialist workshop.
- Fill up with oil.
- Clean the oil tank cap.
- Clear the oil outlet
- Re-sharpen or replace the chain.
- Adjust the chain tension.
- Re-sharpen or replace the chain.
- Replace the chain.
- Reinstall the saw chain with the
teeth facing in the correct direction.
18.07.2023 11:01:48 18.07.2023 11:01:48