Publicidad
Idiomas disponibles
Idiomas disponibles
Adi ,
te
Doot s
Your refrigerator has two adjustable, front leveling screws - one
on each side of the refrigerator base. If your refrigerator seems
unsteady or you want the door to close more easily, use the
instructions
below.
1. Remove the base grille. Grasp the grille firmly and pull it
toward you.
2.
Raise or lower the cabinet.
Using a %" hex driver, turn the roller adjustment
screw(s) on
each side to raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the adjustment screws and
rollers. This makes it easier to turn the screws. It may take
several turns of the roller adjustment screw to adjust the tilt of
the refrigerator.
•
To raise, turn the roller adjustment screw to the right.
•
To lower, turn the roller adjustment screw to the left.
Turn the brake foot clockwise until it is firmly against the floor
to keep the refrigerator from rolling forward when the freezer
drawer is pulled open.
A. Rear roller adjustment screw
B. Front roller adjustment screw
C. Brake foot
3.
NOTE: Your refrigerator may have a rear roller adjustment
screw on each side. To raise or lower the rear of the
refrigerator, use a %" hex driver to turn the screws.
Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise.
It may take several
more turns, and you should turn both screws the same
amount.
4. Replace the base grille.
Please read before using the water system.
Immediately after installation, follow the steps below to make
sure that the water system is properly flushed.
1. Turn off the ice maker by opening the freezer door and lifting
up the wire shutoff arm as shown.
2.
Install the interior water filter. The interior water filter mounting
bracket is located on the left side wall of the refrigerator
compartment.
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Remove blue bypass cap and retain for later use.
Carefully remove the interior water filter from its
packaging. Remove the sealing label from the end of the
filter and insert it into the filter head.
Gently rotate the filter clockwise until it stops. Then snap
the filter cover closed.
3.
4.
5.
Press the Water button on the dispenser control panel. Use a
sturdy container to depress and hold the dispenser lever for
5 seconds, then release it for 5 seconds. Repeat until water
begins to flow. Once water begins to flow, continue
depressing and releasing the dispenser lever (5 seconds on,
5 seconds off) for an additional 2 minutes. This will flush air
from the filter and water dispensing system. Additional
flushing may be required in some households. As air is
cleared from the system, water may spurt out of the
dispenser.
NOTE: After five minutes of continuous dispensing,
the
dispenser will stop dispensing water to avoid flooding. To
continue dispensing,
remove the container and press the
dispensing lever again.
Inspect the filter system for water leaks. If you see water
leaks, see the "Troubleshooting"
section.
Turn on the ice maker by opening the freezer door and
lowering the wire shutoff arm as shown. Please refer to the
"Ice Maker" section for further instructions on the operation
of your ice maker.
•
Allow 24 hours to produce the first batch of ice.
•
Discard the first three batches of ice produced.
Publicidad
