Retekess TD112 Manual Del Usuario página 12

Key Set (Set the Key Name)
1.In the standby state, press and hold (about 1s) "A " button to enter setting
mode
2.Press the "A" or "B" button to select "Key Set"
3.Press and hold (about 1s) "A" button to enter sub-menu, it shows the key
name, serial number and selection box
4.Press the "A" or "B" button to select the desired value
5.Press the corresponding key from call button that need to defined the key
name, the serial number will become the key value at the same time, the
key set it completed.
If the user use Watch Pager Software to set the custom key name, press
"A" and "B" buttons at the same time to switch between the custom and the
default key name.
6.In the "Choose R" working mode, press and hold (about 1s) "A" button to
select or cancel the selection
7.Press and hold (about 1s) "B" button twice to exit the setting mode
NOTE
Only one key name can be set for a key, it shows "FF" on the screen if
there is no serial number for the key name. If the watch pager does
not respond when the call button is pressed after pairing, please refer
to the above steps to set the key name, Or set the key name through
the Watch Pager Software.
(Note: When you use the Watch Pager Software to custom the key name,
the cancel button needs to be edited as "CANCEL"）
Language Setting
10