Publicidad
Zipper Sewing (Continued)
• TO sew
_1_1/8" (0.4cm) fabric margin
(_ Zipper teeth
(_ Zipper tape
(_ Forward edge of zipper foot
Sewing direction
[] Fold back the upper layer seam allowance. Fold back
the lower layer seam allowance to leave a 1/8" (0.4 cm)
margin of fabric (_.
Place zipper teeth next to margin edge and pin margin to
zipper tape.
Align forward edge of zipper foot(_with
margin edge.
Return thread tension and stitch length to original
settings. Sew a seam the entire length of zipper tape,
removing pins as you go. Before reaching pull-tab, unzip
a few inches to clear a path for the stitch. Remove fabric
and close zipper.
[] Take the upper fabric layer and lay it fiat over the zipper.
Beginning above pull-tab at top of zipper tape, sew a
seam about 3/8" to 1/2" (approx. 1.3 cm) distance from
the basting stitches. Stop sewing at a position just below
the zipper bottom stop.
Turn fabric 90 ° and sew to meet the bottom seam. Sew
in reverse a few stitches to lock.
Once both sides of zipper are sewn, use seam ripper to
open the basting stitch.
S
\
S
[]
(1/8")
(0.4 cm)
[]
J
_._p3/8"~
1/2")
rox. 1.3 cm)
36
Publicidad
