AENO SM1 Guia De Inicio Rapido página 10

b. For carpet cleaning, attach the small cloth cover (12) and install the carpet
cleaner (14) on the main brush (11). Both the cloth cover and the carpet
cleaner lugs should be facing backwords (against the brush stroke).
4. Attach the main brush (11) to the assembled extension tube (15). You may use
the extension hose instead of the tube, as well as the additional brushes (7),
(8), (9) or (10) instead of the main brush.
5. Plug in the power cord of the steam mop into the mains socket to get
started. The power cord (4) is rigidly integrated into the mop body.
6. Please note the indicator statuses (See figure d). The indicator
flashing red upon plugging in the plug. To start operation, press and hold the
indicator for at least 2 seconds – it will turn blue. Steam will start to come
out after 17 seconds of operation. To stop the steam, press and hold the
indicator for at least 2 seconds – it will turn red. When the indicator
orange, it means that the steam is at its maximum. To switch to normal
steam mode, press the indicator
the current steam temperature.
7. When the cleaning process is finished, you should disconnect the mop from
the source of power and put it upright into the wall bracket. Please make
sure that the mop handle is properly installed in the bracket holder. The wall
bracket shall be vounted using the screw and the dowel or the 3M tape that
is within the package content. In the case of a regular use of the mop, you
can also store it horizontally and unassembled. In this case, it is necessary to
drain the water from the tank.
Troubleshooting
1. Steam is not generated. Possible reasons: The water tank is not installed or
incorrectly installed in the mop, or there is no water in the tank. Solution:
Install the water tank correctly, or fill in the tank with water.
10
– it will turn white. The indicator
will start
aeno.com/documents
is
shows