Publicidad
Idiomas disponibles
Idiomas disponibles
•
The product must be anchored to a surface which ensures tensile strength equal to or greater than
the weight of the appliance: do not install on false ceilings, panelling, coverings and the like, unless
the respective degree of tightness has been verified.
Ensure a distance between the perimeter of the rotating surface of the blades and the surrounding
•
walls of at least 50 cm on each side.
•
The device must not be placed within the opening range of doors and windows, rolling shutters,
curtains, rockers, movable walls or the like.
•
Do not use the product if it has been dropped: carry out an integrity check by competent technical
personnel.
•
Do not put your hands or other parts of the body within the range of action of the appliance while
it is running: the range of action refers to the surface covered by the blades during rotation.
•
Do not place any objects in the moving area of the fan during operation: this behavior involves the
risk of injury; in any case avoid stopping the rotation of the fan during operation and constantly
check that this circumstance cannot occur accidentally.
•
Before proceeding with cleaning operations, make sure that the appliance has been off for at least
15 minutes and that the electrical switch located upstream of the appliance is deactivated.
•
To clean the product, use a damp cloth and avoid any abrasive or aggressive detergent; wait for it
to dry completely before putting it back into operation.
Do not install or use the appliance in direct sunlight or in the range of action of other ventilation
•
appliances, in environments that are excessively humid, saturated with gases, vapors or other
suspended substances, near open flames, flammable, oxidizing or explosives.
•
Do not use near burners, fireplaces, pellet stoves, gas cookers and the like, especially if
extinguishing these flames would cause gas leaks.
•
Do not use the product to extinguish flames.
•
Make sure to connect the appliance to a standardized system built according to state-of-the-art
criteria, equipped with a differential switch and magneto-thermal switch.
•
Do not connect the appliance to devices such as timers, remote controls or automatisms.
Do not leave packaging materials unattended, especially plastic bags, as they could be dangerous
•
for children or people with reduced physical or cognitive abilities.
•
Do not disassemble the appliance, even after it has been decommissioned. At the end of its life
cycle, it must be disposed of in accordance with current legal requirements detailed in the
following chapter.
Do not modify the appliance for any reason: no performance improvement will be obtained as a
•
result of interventions on its component parts. Any modification invalidates the legal guarantee
and the safety requirement, with possible risks for the user.
•
Do not remove or modify the safety devices with which the product is equipped.
•
Never immerse any part of the appliance in water or other liquids: avoid spraying any substance
near the appliance or directly on it, especially if it is running.
•
Any slight smoke or burning smell upon initial start-up is normal and does not constitute an
anomaly: this emission should stop after a few seconds of operation.
•
Periodically check the state of conservation of the various parts of the appliance: if you notice
breakages or anomalies, do not use it and contact qualified personnel; pay particular attention to
the condition of the cable.
•
If the appliance is not going to be used for a long time, it is advisable to disconnect it from the
mains and not just stop it using the specific command.
•
Before restarting the appliance following a stop, wait for the propeller to have finished rotating by
inertia.
Publicidad
