Scheppach HF50 Manual página 26

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed
Note:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you to familiarise
yourself with your product and to use it for its intended
purpose.
The operating manual includes important instruc-
tions for the safe, proper and economic operation of
the product, for avoiding danger, for minimising repair
costs and downtimes and for increasing the reliability
and extending the service life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the product in your country.
Keep the operating manual package with the power
tool at all times and store it in a plastic cover to pro-
tect it from dirt and moisture. They must be read and
carefully observed by all operating personnel before
starting the work.
The product may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
26 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of identical products must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Product description (Fig. 1-27)
1. Left table width extension
2. Top pressure bar
3. Work table
4. Right table width extension
5. Crank wheel
6. Front pressure bar
7. Overload switch
8. On/off switch
9. Speed control
10. Mitre gauge
10a. Star grip nut
11. Pressing combs
12. Moving stop
13. Base body
14. Horizontal stop supports
15. Vertical stop supports
16. Fastening clamp
17. Stop bar
18. Holder for pressure bar, top
19. Holder for pressure bar, front
20. Suction adapter
21. Protective cover
22. Push grip
23. Open-ended spanner WAF19
24. Open-ended spanner, size 24
25. Allen key, 4 mm
26. Allen key, 5 mm
27. Table inlay
28. Scale
29. Clamping screw
3. Scope of delivery (Fig. 1-3)
• 1x tabletop milling machine
• 1x left table width extension (1)
• 1x top pressure bar (2)
• 1x right table width extension (4)
• 1x crank wheel (5)
• 1x front pressure bar (6)
• 1x transverse stop (10)
• 2x pressing combs (11)
www.scheppach.com