Imperia Restaurant RBT Manual De Instrucciones página 9

1456 restaurant elettronica con garanzia-08-2020.qxp_1455 rest elettronica multil 22/09/20 15:40 Pagina 9
CONTROL DEVICES
(fig.2)
During operation the Leds (S1 S2 S3) turn on to indicate the machine power as the processing
effort gradually increases.
If the machine is forced beyond the established safety limits, Led (S4) lights up and the
machine stops. To start it again, press the main switch (L) moving it to position 0, turn
the knob (R) counter-clockwise, press the main switch (L) again and move it to
position "I".
USE OF THE PASTA MACHINE
(fig.3)
BEFORE USE: follow the instructions described in the paragraph "Cleaning and main-tenance"
1 - Place the machine on a suitable surface.
2 - Attach the pasta hopper (A) to the supports upwards.
3 - Insert the plug (E) into the socket and press the main switch (L) to the "I" position. After turning
the regulator knob (P) clockwise until it is in position "10", insert a part of the previously prepared
dough between the protection rods (A1) until you reach the machine's pull-sheet rollers; it is neces-
sary that the dough is lightly smoothed by hand before inserting it between the protective rods to
facilitate entry and obtain a first shaping of the sheet.
4 - To increase or reduce the speed of the stretching rollers (O) turn the knob (R) to adjust to the
required speed.
ATTENTION! Do not use knives or other utensils which might damage the rollers.
IT IS EXPRESSLY FORBIDDEN: Apply pressure to the pasta (to facilitate its insertion
between the protection rods A1) with improper tools.
5 - To roll out the pasta and obtain a pasta sheet turn the regulator (P) anti-clockwise to reduce the
distance between the drawing rollers; insert the sheet obtained with the previous molding between
the protection rods until the dough is gripped by the forming rollers. Repeat this operation until the
sheet is of the required thickness.
TO DISMANTLE THE MACHINE (on finishing work): turn the master switch to position "0", remo-
ve the plug from the socket, release the pasta hopper (A) from the supports (C1).
AFTER USE: follow the instructions described in the paragraph "Cleaning and maintenance".
USING THE SIMPLEX CUTTING AND ROLL ACCESSORY
(fig.s.4,5,6)
BEFORE USE: follow the instructions in the paragraph "Cleaning and maintenance";
1 - Place the machine on a suitable surface.
2 - Insert the supplied pin (F) in the pasta hopper (B)
3 - Insert the pasta hopper (B) in the special seat (G1).
4 - Turn the taglia-sfoglia (B) clockwise until it is completely fixed (Fig. 6)
5 - Fit the pasta hopper (A) on to the supports (C1).
6 - Plug in the machine and turn the master switch to position "I".
9