cecotec IRONHERO 3200 I-PUMP ABSOLUTE Manual De Instrucciones página 34

ENGLISH
5. TROUBLESHOOTING
Problem
Not enough or too much heat.
No steam or leakage.
Steam burst or vertical
steaming function do not
work properly.
Water leaks from the
soleplate.
Little steam.
Spray does not work properly.
6. TECHNICAL SPECIFICATIONS
Product reference: 01876
Product: IronHero 3200 i-Pump Absolute
Power: 3200 W, 220-240 V~, 50-60 Hz
Technical specifications may change without prior notification to improve product quality
Made in China | Designed in Spain
34
IRONHERO 3200 I-PUMP ABSOLUTE
Possible cause
The temperature knob is
not set correctly or it is
unplugged.
The temperature knob
is set to the minimum
position.
The steam burst function
has been used too often
within a very short period.
The iron is not hot enough.
The temperature knob has
been set to the "0" position.
The iron is not hot enough.
The water amount exceeds
the Max. mark.
Steam holes are blocked.
Little or no water in tank.
Not enough pressure or air
inside.
Solution
Set the temperature knob to
the correct position.
Continue ironing in horizontal
position and wait a few
minutes before using the
vertical steam burst function
again.
Set the temperature knob
correctly.
Press the steam button only
when the symbols on the
display are steady.
Empty the remaining water.
Clean the hole with distilled
water.
Add water to tank.
Press the water spraying
nozzle and the water spray
button several times in a row.