Descargar Imprimir esta página

Domo DO241SV Manual De Instrucciones página 38

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
WALL MOUNT
Please follow below instructions to fix the wall mount:
1.
Drill 4 holes in the wall corresponding to the attachment points of the wall mount.
the distance between the power socket and the upper drill holes is no more than 1.5 metres. The
minimum height for wall mounting is 1.2 metres.
2.
Insert the supplied plugs into the wall.
3.
Fix the wall mount using the supplied screws.
4.
To store the device, simply hang it on the wall mount.
5.
To take the stick vacuum out of the wall mount, push the release hook down.
CHARGING
·
Prior to first use, charge the machine for 24 hours in order to be able to utilize the full capacity of the
battery. The appliance should be charged for 4-5 hours afterwards.
·
Place it back in the wall mount before plugging the adapter into the socket.
·
To extend the life of the battery, the appliance should be fully charged regularly and the battery
should be allowed to drain.
·
The appliance will warm up slightly when charging; this is normal.
·
The battery charge indicator indicates when the appliance has been fully charged. The lights will blink
and will illuminate in turn when the battery is charging. When all the lights are on, the battery is fully
charged.
·
The appliance cannot be used while charging.
USE
·
Press the on/off button to turn the appliance on. The white battery indicator lights will illuminate to
display the battery level. The lights will flash when the battery is low.
·
Use the speed controller button to decrease the speed and increase the usage time. Decreased suction
power provides longer vacuuming times. Press the speed controller button to bring the vacuum to full
power.
·
The autonomy depends on the type of surface. It will work for less time on carpets than on a hard
surface.
·
While vacuuming, warm air will come out of the motor compartment. This is normal.
·
When you switch on the machine, the rotating floor brush at the bottom of the floor nozzle will begin
to turn. This will cause the
·
The machine is equipped with a safety which will ensure that the machine shuts itself off if, for
example, objects which are too large are sucked up, or if
38
DO241SV
dirt in the opening to be shifted and thereby vacuumed up.
fingers become tangled in the floor brush.
Please ensure

Publicidad

loading