Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE FLOOR BRUSH
1.
Remove the floor nozzle from the upright vacuum cleaner. Press the
the floor nozzle and remove it from the machine.
2.
Press the release in and slide the cover upwards. Then push the cover outward to remove it.
3.
Remove the
4.
Remove hairs and other dirt that have wrapped around the floor brush. If you do not clean the floor
brush regularly, it will become damaged and your machine will become unusable.
5.
The rotating floor brush may be rinsed off under running water. Make sure that it is completely
before using it.
6.
Place the floor brush back into the floor nozzle when it is clean.
7.
Slide the cover back and slide it closed again to secure the floor brush.
8.
Push the nozzle back onto the stick. The machine is now again ready for use.
Stuck hairs can
damage the machine or your floor. Always remove the hairs stuck on the brushes.
PROBLEM AND SOLUTION
The machine does not start up.
The appliance has stopped working.
The appliance stopped working and the lights on
the appliance flashed for 10 seconds.
The machine does not vacuum.
Suction power is reduced significantly.
The indicator light does not light up during
charging.
40
DO241SV
rotating floor brush from the floor nozzle.
PROBLEM
release button at the back of
SOLUTION
The battery is empty. Charge the machine.
The appliance has overheated. Allow the
appliance to cool down and clean the appliance.
If the wand or filters are blocked, the appliance
switches to safety mode and the lights of the
appliance will flash. Check and clean the wand and
filters.
·
The filters are dirty.
·
The dust container is full.
·
The floor brush is blocked.
·
The suction opening is blocked.
·
Clean the appliance as described in this
manual.
We recommend that you thoroughly clean
the filter as well as the dust container and the
accessories as described in this manual. If the
filters are saturated, they can be reordered.
·
There is no proper contact.
·
Make sure the adapter is connected properly.
·
Remove the dust on the stick vacuum
connector.
dry
Publicidad
