cecotec IRONHERO 3200 I-PUMP Manual De Instrucciones página 44

ENGLISH
Soleplate
Starch and other types of residues may be easily removed from the soleplate with a damp
cloth. Do not use nickel balls to clean the soleplate or place the iron on rough surfaces to
avoid scratching the soleplate finish. If synthetic fabrics are ironed at high temperature, both
the fabric and the soleplate of the iron could be damaged. The best way to remove synthetic
residue from the soleplate is to heat it up and iron over an old cotton rag.
Warning
Do not use steam iron cleaners with this iron since they could damage its parts.
Storage
- Disconnect the iron from the mains supply.
- Empty the tank by turning the iron upside down and gently shaking it.
- Allow the iron to cool down completely.
- Wind the power cord around the base of the iron.
- Store the iron in a vertical position.
5. TROUBLESHOOTING
Problem
Not enough or too much
heat.
No steam or leakage.
Steam burst or vertical
steaming function do not
work properly.
Water leaks from the
soleplate.
44
IRONHERO 3200 I-PUMP
Possible cause
The temperature knob is
not set correctly, or it is
unplugged.
The temperature knob
is set to the MIN position.
The steam burst function has
been used too often within a
very short period. The iron is
not hot enough.
The temperature knob has
been set to MIN.
The iron is not hot enough.
Water is over the max mark.
Solution
Set the temperature knob to
the correct position.
Continue ironing in horizontal
position and wait a few
minutes before using the
vertical steam burst function
again.
Set the temperature knob
correctly.
Wait until the red light
indicator turns red.
Empty the remaining water.