Publicidad
Idiomas disponibles
Idiomas disponibles
If you decide not to use the appliance anymore, we recommend that you make it
inoperative by cutting the power cord (first make sure you have removed the plug from the
socket) and make those parts that are dangerous if used for play harmless. by children.
Do not use the product if it emits smoke or bad odors, abnormal noises, if it is clearly
deformed or damaged. In this circumstance, disconnect the power supply, unplug the
appliance and contact specialized technical personnel.
INSTALLATION
After removing the packing materials, check the integrity of the appliance; if you are
unsure, do not use it and ask for qualified professional help. The packing materials (plastic
bags, polystyrene foam, nails, etc.) must be kept out the reach of children because they are
potential sources of danger; but dispose of them in accordance with current law.
Before connecting the appliance, check that the voltage shown on the data plate matches
that of your electricity and that the electric plug is grounded. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with
another more suitable type by professionally qualified personnel, who will make sure that
the section of the wires of the outlet is appropriate for the absorbed power of the
appliance. In general, the use of adapters or extension cords is not recommended; if their
use is indispensable, they must conform to existing safety standards and their current
capacity (amperes) must not be less that the maximum of the appliance.
Position the appliance far from other sources of heat, inflammable materials (curtains,
carpets, etc.), inflammable gases or explosive materials (spray cans) and from materials that
can deform on exposure to heat. Make sure that there is 120 cm of free space in front of
the appliance and 50 cm on the sides.
Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane
(the appliance could upset). Make sure the safety system get in touch with the floor,
otherwise the appliance doesn't work.
Make sure that the cable is correctly positioned, that it is not touching hot elements or
sharp edges, is not wound around the utensil, is not twisted up on itself or in the way to
prevent the utensil from being pulled over. Check that you cannot trip over to prevent
accidental falls or harm to persons.
All repairs should be made by a competent qualified electrician. In any case you should
return the appliance to this service.
DESCRIPTION OF THE APPLIANCE
ASSEMBLY AND OPERATION
1)
Switch
2)
Protection grid
3)
Heating elements
4)
Front panel
5)
Base
10
Publicidad
