Tripp-Lite NFI-U08-2A Manual Del Propietário página 11

Cabling
Connect one end of an RJ45 Ethernet cable (see Optional
Accessories) into the switch's RJ45 Ethernet port. Connect
the other end to a network device. Cat5e cable or above is
recommended.
• Ports 1-8 of the switch support Fast Ethernet (10/100 Mbps)
• All ports support auto-negotiation and auto MDI/MDI-X to
eliminate the need for crossover cabling.
DIP Switch Settings
ON
PWR
OFF
ON
RPS
OFF
ON
P1
OFF
Primary power alarm reporting is enabled
Primary power alarm reporting is disabled
Redundant power alarm reporting is enabled
Redundant power alarm reporting is disabled
Port 1 link alarm reporting is enabled
Port 1 link alarm reporting is disabled
11