Tripp-Lite NFI-U08-2A Manual Del Propietário página 8

Wiring Requirements
Wiring Power Input
You can use "PWR" for Primary Power input and "RPS" for
Redundant Power Input. Check the polarity while connecting. The
top view of the Terminal Block is shown in the figure below:
PWR
RPS
ALM
Terminal Block
CAUTION:
• Use copper conductors only.
• Wiring cable temperature should support at least 105°C
(221˚F).
• Tighten the wire to a torque value 0.5 N•m (4.5 in•lb).
Note: The wire gauge for the terminal block should range between 12 and
24 AWG.
8