Operating And Display Elements - Sirona SIVISION 3 Instrucciones De Uso

Sirona Dental Systems GmbH
Operating Instructions for the flat screen SIVISION 3
3

Operating and display elements

No. Symbol Control
Menu / Select
Menu / Select
Plus
Minus
ON/OFF switch
Ready indicator
60 33 927 D 3322
D 3322.201.08.02.02
The unused male or female connectors on the back of
the LCD monitor may not be touched in order to prevent
possible damage due to electrostatic discharge.
Do not assign unused male or female connectors to oth-
er devices unless authorized to do so by the manufactur-
er, and use only accessories from the respective manu-
facturer for this purpose.
Function
For displaying the OSD menus
This key must also be used for selecting ("up") the OSD control options on the
screen.
For displaying the OSD menus
This key must also be used for selecting ("down") the OSD control options on the
screen.
Press this key to increase the value of the selected OSD control options.
• Press this key to decrease the value of the selected OSD control options.
• Key is used for selecting the signal input menu (video or PC mode). This function
is available only as long as no further menu is displayed.
For switching the LCD screen on and off
This LED indicates the statuses of the different operating modes of the monitor.
• green: an input signal is present at the selected signal source
• yellow:
for AUTO signal input selection: no input signal is present at any input
for permanently set signal source: no input signal is present at the set input
• off: the monitor is switched off or no voltage is applied
3 Operating and display elements
CAUTION
7