Melchioni Family ZOE Manual De Instrucciones página 13

5. USE
Battery charging: The mixer is supplied with a not fully charged battery: for best performance it is
advisable to fully charge it before use. Charging is done by connecting the USB-C cable to the
appropriate socket provided in the charging stand, then connecting the other end of the cable to
the charger; the connector is reversible, therefore it can also be inserted upside down. It is then
necessary to rest the motor body on the stand, with the connector for the accessories facing
downwards, taking care to match the plug with the socket on the upper and rear part of the motor
body, with a slight pressure on the upper part until you hear one click. Once you have verified the
correct insertion of the plug, insert the charger into the wall socket and check that the recharge
starts with the sequential lighting of the LEDs of the indicator (D), with a number of LEDs gradually
increasing until fully recharged, that is when all the LEDs are on steady. This operation must be
performed every time the charging indicator lights up with a single LED; the charging time is
approximately 5 hours. When charging is complete, disconnect the USB cable from the motor body
and the charger from the wall socket.
Stem application with stainless steel blade: the shank must be connected to the motor body by
applying the appropriate joint (opposite end to the blade) to the lower part of the motor body,
then rotating it in one direction, while exerting at the same time a firm push in the direction of the
motor body, held firmly with the other hand. Once the parts are completely aligned, the stem joins
the motor body with a sharp click and the two parts will be stably joined.
Mixer assembling: The whisk of the mixer (K) must be inserted into the joint before it can be used:
place the joint on a flat and stable surface with the tip facing upwards, then insert the whisk pin
into the upper hole. Rotate the whisk by pressing it downwards until you hear a further insertion
with the relative double click; the mixer is ready for use.
Mixer application: The application of the mixer takes place in the same way as the stem with
blade: therefore refer to the previous paragraph for details.
Mincer assembling: Insert the double blade vertically in the center of the 500 ml container, paying
the utmost attention to the cutting edge, to avoid injuries or cuts; place the lid on top of the
container making it match the perimeter, then, holding the container still, rotate the lid to the left,
in order to facilitate the insertion of the latches in the appropriate grooves, until the rotation stops.
Place the motor body on the opening above the cover, rotating it until it is fully inserted,
identifiable by the sudden lowering and consequent snap.
Disconnection of stem or mixer: The installed accessory can be removed by pulling it in the
opposite direction to the application, while simultaneously pressing the two release buttons (E).
Make sure the rotation stops completely before disconnecting; in any case, always pay the utmost
attention to contact with moving parts. Once unlocked, release the buttons.
Food preparation: The food material must be divided into parts with dimensions not exceeding 15
mm, in order to avoid that the mincing is difficult or not very effective; any excessively hard
elements, such as bones or fruit stones, must be removed. It is advisable to slightly hydrate the
food if it is too dry, compatibly with the expected result. Avoid overloading the container in which
you intend to perform the mince, in order to prevent it from overflowing with rotation.
Using the mixer: The appliance must be strictly started only if immersed in the bowl containing the
food material: operation in free air must be avoided. To start the operation, press the release
button (A) to cause the lighting of the first green LED at the bottom, then, within four seconds,
press the start button (B). The mixer remains in operation only for the time during which the start
button is pressed; after four seconds from stopping, it will be necessary to press the release button
again before being able to start the rotation, again within four seconds. If the mixer is started more
than four seconds after pressing the button (A), the safety lock status is signaled through the
12