VICAIR ACTIVE 02 Manual Del Usuario página 7

Replacement covers can be purchased
separately.
Disposal
The disposal and recycling of used devices and
packaging must comply with the applicable
legal regulation. Ensure the product is cleaned
prior to disposal to avoid any risk of
contamination.
MAINTENANCE AND CLEANING
Warning! Every three months, check the
product for wear and deflated cells. In case of
serious damage, or a large number of deflated
cells, do not continue to use the product.
Consult your Assistive Technology Professional.
Warning! Make sure the SmartCell liners are
placed in the correct compartment (see
SmartCell liner label).
Caution! Do not dry clean, steam clean or
autoclave the product. The product cannot
withstand excessive heat or pressure. When the
given cleaning instructions are not followed, it
is very likely that the product and/or the
product's cover will age more rapidly.
Caution! Do not use aggressive or abrasive
cleaners, or sharp objects to clean the cushion.
Caution! Remove foam inlay before washing
this cushion in a washing machine.
Caution! Do not use the foam inlay without the
foam inlay liner.
Caution! Do not place the topside of the Vicair
O2 cushion against the glass of the washer
door.
Caution! Excessive washing may influence the
aging of this product.
Cleaning the Vicair Active O2
After you have emptied the storage pouch and
removed the foam inlay, your Vicair Active O2
cushion can be machine washed at 60°C / 140
°F using an anti-crease cycle and mild
detergent. You do not need to remove the
SmartCell liners before putting the cushion into
the washing machine. Make sure the topside of
the cushion is not placed against the glass of
the washer door. Do not load the machine with
more than half of its maximum load weight.
Spin speed should be reduced. When using a
machine with agitator, make sure that the
cushion can move freely within the drum. Do
not use any chlorine bleach and do not dry
clean, steam clean or autoclave! Do not tumble
dry your Vicair Active O2 cushion but let it air
dry (5-6 hours).
Cleaning the Vicair Active O2 foam inlay
Do not machine wash the foam inlay and do not
immerse it in water or any other liquid. To clean
the foam inlay you first remove it from its
compartment.
• Cleaning the foam inlay liner
Take the foam out of the foam inlay liner.
The emptied liner can be machine washed
at 60°C. Follow the washing instructions on
the label attached to the inside of the liner.
• Cleaning the foam
Take the foam out of the foam inlay liner
and clean it by using a disinfectant spray.
7