GE PGP9830 Manual De Instrucciones página 27

Installation Instructions
INSTALLING THE COOKTOP
r_] ATTACHING A BLOWER
TRANSITION DUCT
Use a blower transition duct for all downward duct
installations to connect to 6" round standard ductwork. This
3_4"x 10" rectangle to 6" round transition duct is available at
your local building supply store.
Screw
(on other
side)
Install the transition duct to the blower outlet. Secureall
joints with duct tape to assure an airtight seal.
r_ BLOWERELECTRICAL CONNECTIONS
• Loosenthe two screws and remove and discard the sheet
metal strap covering the 5-pin connector on the cooktop
bottom. Savethe screws for reinstallation later.
screws and
discard strap
° Connect the 5-pin plug on the blower assembly to the
matching 5-pin receptacle on the bottom of the cooktop.
B-pin
connectors
• Foldall wires into the electrical enclosure.Securethe
enclosure with the screws removed earlier,making sure
that no wires are trapped.
"" B-pin
connectors
-- Electrical
enclosure
Flexible
conduit
r_] CONNECTINGTHE DUCTWORK
Connect the ductwork prepared in Steps 5 and 6
to the blower.
!
Z
!
0
Z
!
Z
¢D
--I
C
d_
--I
!
0
Z