GE PGP989 Manual De Uso

High Altitude
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
instructions for future reference.
FOR YOUR SAFETY:
WARNING –
installed by a qualified service agency in accordance
with the manufacturer's instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions
is not followed exactly, a fire, explosion or production of
carbon monoxide may result, causing property damage,
personal injury or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer's instructions supplied with the kit.
CAUTION –
conversion, shut off gas supply to the appliance prior
to disconnecting the electrical power.
49-80561
08-08 JR
Printed in the United States
Save these
Observe all
Be sure to leave these
Keep these
This conversion kit shall be
Before proceeding with the
Gas Cooktop
PGP989
ge.com
or
Visit our Website at:
• This cooktop is factory set for natural gas operation.
Conversion to high altitude operation should be
performed by a qualified technician or installer. Keep
these instructions for future reference. When converting
to high altitude, save the original parts for possible
future use.
Use the following kit depending on the type of gas
the cooktop is set for:
Natural Gas High Altitude Conversion Kit ........WB28X10114
LP Gas High Altitude Conversion Kit...................WB28X10115
• Product failure due to improper installation is not
covered under the GE Appliance Warranty.
TOOLS YOU WILL NEED
Adjustable wrench 9/32" (7 mm) Nutdriver
Small, thin-blade flat screwdriver with approximately 1/8"
blade width is needed to access the calibration screw.
PARTS INCLUDED WITH KIT
PART
Brass orifices
Stick-on rating label
Installation instructions
1
T15 Torx driver
QUANTITY
4
1
1