Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL MOWER
Ensure tires are properly inflated to the PSI
shown on tires. If tires are over or under
inflated, it may affect the appearance of your
lawn and lead you to think the mower is not
adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
t. With all tires properly inflated and if your
lawn appears unevenly cut, determine
which side of mower is cutting lower.
2, With a 3/4" or adjustable wrench, turn
lift link adjustment nut (A) to the left to
lower LH side of mower, or, to the right
to raise LH side of mower.
Turn nut
rightto
raise
mower
Turn
nut
left to
lower
mower
NOTE: Each full turn of adjustment nut will
change mower height about 3/16" (4,7 mm),
3. Test your adjustment by mowing some
uncut grass and visually checking the
appearance, Readjust, if necessary, until
you are satisfied with the results,
PRECIS!ON SIDE-TO-SIDE ADJUSTMENT
1. With alttires properlyinflated, parktractor
on level ground or driveway.
_;_CAUTION:
Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
2. Raise mower to its highest position.
3. At both sides of mower, position blade
at side and measure distance "A" from
bottom edge of blade to ground. The dis-
tance should be the same on both sides.
4. If adjustment is necessary, see steps in
Visual Adjustment instructions above.
5, Recheck measurements; adjust if neces-
sary until both sides are equal.
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck
must be level side-
to-side.
To obtainthe
best cutting results, the mower
blades
should
be adjusted
so the front tip
is 1/8 to 1/2" (3,t to 12,7 ram) (lower than
the rear tip when the mower is in its highest
position,
_lh, CAUTION:
Blades
are sharp.
Protect
your hands with gloves and/or wrap blade
with heavy cloth.
• Raise mower to highest position.
• Position
any blade so the tip is pointing
straight forward. Measure
distance "B" to
the ground at front and rear tip of blade.
• If front tip of blade is not 1/8 to 1/2" (3,1
to 12,7 mm) lower than the rear tip, go to
the front of tractor.
• With
an 11/16"
or adjustable
wrench,
loosen jam nut "A" several turns to clear
adjustment
nut "B".
• With a 3/4" or adjustable
wrench,
turn
front link adjustment
nut"B" clockwise (r_)
(tighten) to raise the front of mower, or,
counterclockwise
(_-_) (loosen)
to lower
the front mower.
Tighten adjust
Loosen adjust
nut "B" to
nut "B" to
raise mower
lower mower
Loosen jam nut "A" first
NOTE: Each full turn of adjustment nut will
change mower height about 1/8" (3,1 ram).
• Recheck measurements, adjust if neces-
sary until front tip of blade is 1/8 to 1/2"
(3,1 to 12,7 mm) lower than the rear tip.
• Hold adjustment
nut in position with
wrench and tighten jam nut securely
against adjustment nut.
22
Publicidad
