Publicidad
Mitre table locks
The mitre table locks (15)
are used to lock the table
at the desired mitre angle
(fig. D).
The mitre saw cuts from 0°
to 45° both left and right. To
adjust the mitre angle loosen
the mitre table locks and
rotate the mitre table to the desired position. The mitre
table features positive click stops at 0°, 15°, 22.5°, 30°
and 45° for quick setting of common mitre angles.
WARNING. Be sure to tighten the mitre table locks before
making a cut. Failure to do so could result in the table
moving during the cut and cause serious personal injury.
Bevel lock
The bevel lock (7) is used to
set the blade at the desired
bevel angle (fig. E). The
mitre saw bevel cuts from
0° to 45° to the left. To
adjust the bevel angle loosen
the bevel lock and adjust
the saw arm to the desired
bevel angle.
WARNING. Be sure to tighten the bevel lock before making
a cut. Failure to do so could result in the saw arm moving
during the cut and cause serious personal injury.
Spindle lock button
The spindle lock button (18)
prevents the blade in the
saw from rotating (fig. F).
Depress and hold the spindle
lock button while installing,
changing, or removing the
blade.
8|Español
D
E
F
F
Rotating lower
blade guard
The rotating lower blade
guard (5) provides protection
from both sides of the blade
(fig. G). It retracts over the
upper blade guard (4) as
the saw is lowered into the
workpiece.
Turning on and off
1. To turn the saw on depress
and hold the on/off trigger
switch (16) (fig. H).
2. To turn the saw off release
the on/off trigger switch
(16).
Setting the table square with the blade
1. Make sure that the electrical plug is removed from the
power point.
2. Push the saw arm (1) down to its lowest position and
engage the release knob (2) to hold the saw arm in the
transport position.
3. Loosen the mitre locks (15).
4. Rotate the table (12) until the pointer is positioned at 0º.
5. Tighten the mitre locks (15).
6. Loosen the bevel lock (7)
and set the saw arm (1) at
0º bevel (the blade at 90º
to the mitre table). Tighten
the bevel lock (7).
7. Place a set square against
the table (12) and the flat
part of the blade (fig. J).
G
H
J
Publicidad
