Electrolux EI06HIPIKS Guia De Instalacion página 9

Ventilador interno de 600 cfm y 1200 cfm para campanas extractoras de cocina

Ocultar thumbs

página de 34

/ 34
Marcadores

Idiomas disponibles

Prepare Location

Disconnect power.

Determine which venting method to use: roof or

wall exhaust.

Select a flat surface for assembling the hood

insert. Place covering over that surface.

•

It is recommended that the vent system be

installed before hood is installed.

•

Before making cutouts, make sure there is proper

clearance within the ceiling or wall for exhaust vent.

•

Hood insert should be installed a minimum 24"

(61 cm) above an electric cooktop surface and 30"

(76.2 cm) above a gas cook top surface.

The maximum recommended height over both

cook tops is 36" (91.44 cm).

•

Check that all installation parts have been

removed from the shipping carton.

Using 2 or more people, lift hood insert onto

covered surface.

Remove the filters. See the "Cleaning"

section on page 15.

The hood insert attaches to the hood cabinet using

four mounting screws and washers. These are

included in the Hood Insert Hardware.

NOTE: Hood cabinet must be capable of supporting

75 Ib (34 kg).

Prepare Hood Insert for mounting into cabinet

Mark the locations for the four mounting screws

on the hood cabinet as shown below.

Using a 1/8"(3 mm) drill bit, drill the 4 holes.

A. Centerline

-I

-e-

_,-i

Mounting_

"_'°

h°les

"_o

A. Centerline

Using a jigsaw or keyhole saw, cut out the rectan-

gular clearancehole for the upper hood inserthousing.

Complete Installation

Determine and make all necessary cuts in the

wall or roof for the vent system. Install the vent

system before installing the cabinet hood insert.

See the "Venting Requirements" section.

Determine the location where the power supply

cable will be run through the wall.

Drill a 1W' (3.2 cm) hole at this location.

Pull enough power supply cable through the wall

to allow for easy connection to the terminal box.

Remove terminal box cover and set aside.

Remove knockout from the top of the vent hood

and install a UL listed or CSA approved 1/2"

(1.3 cm) strain relief.

Place the hood insert near its mounting position

and run the power supply cable through the strain

reliefinto terminal box (enoughto make connection).

Tighten the strain relief screws.

Using 2 or more people, lift the hood insert into

hood cabinet.

10. Fasten the hood insert using four 5 x 45 mm

screws to the hood cabinet and tighten securely.

Upper

Hood

Insert Motor

Housings

4 mounting

.................................. _

screws

........................................................................

WARNING

EXCESSIVE WEIGHT HAZARD

USE TWO OR MORE PEOPLE TO MOVE AND