Publicidad
Idiomas disponibles
Idiomas disponibles
IN THE BOX
IR
remote
control
incl.
battery
INSTALLATION NOTE
Attention! The electrical connection may only be carried out by persons who
have the appropriate electrical knowledge and qualifications. There is a risk
of short-circuiting or injury to persons if the work is not carried out correctly!
Always disconnect the system from the power supply (pull out the mains plug
and secure it against reconnection!) when carrying out connection work!
The receiver is compatible with tubular motors and synchronous motors
with a 4-wire connection. Please refer to the connection diagram (page 6).
Please observe the electrotechnical standards and the following points:
•
Minimum distance receiver to floor: 150cm
•
Minimum distance receiver to ceiling: 30cm
•
Minimum distance receiver and remote control: 30cm
REMOTE CONTROL
The remote control is operated with a 3V button cell (type: CR2032).
If the remote control no longer works, replace the battery.
To do this, open the rear cover of the battery compartment and you can see
the position of the battery. Replace the battery with a battery of the same type
and close the cover again.
IR receiver
3
Publicidad
