Philips Sonicare DiamondClean HX9361/62 Manual De Instrucciones página 10

10
English
11 USB cord
Note: The content of the box may vary based on the model
purchased.
Preparing for use
Attaching the brush head
1 Align the brush head so the bristles point in the same direction as
the front of the handle (Fig. 2).
2 Firmly press the brush head down onto the metal shaft until it
stops.
Note: It is normal to see a slight gap between the brush head and the
handle.
Charging the appliance
1 Plug the charger into an electrical outlet.
2 Place the charging glass on top of the charging base and place the
handle in the glass (Fig. 3) or place the charger stand on top of the
charging base. Place the handle in the stand (Fig. 4).
- The charge indicator flashes green until fully charged.
- Rapid yellow flashing indicates charge is extremely low (fewer
than 3 uses left).
Note: It takes at least 24 hours to fully charge the battery.
This charger is designed to properly charge only one handle at a time.
This charger is not compatible with other models of Sonicare.
Using the appliance
Brushing instructions
1 Wet the bristles (Fig. 5).
2 Apply a small amount of toothpaste on the bristles (Fig. 6).
3 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline (Fig. 7).
Note: Keep the center of the brush in contact with the teeth at all
times.