Publicidad
Idiomas disponibles
Idiomas disponibles
1. Power on the heater, and then press "
pairing, the WIFI symbol flashes three times and sends out the paring code to indicate that paring is
taking place, there will be one beep sound from heater after success.
Note:
1. Please turn off the heaters that you do not want to be paired before pairing.
2. If the remote control needs to be replaced, please power on the heater again, and then
complete the pairing within five minutes. If the pairing is not finished within five minutes, the
pairing mode will be off and you will need to repeat the above steps to pair again.
2. Press "
" to turn on the heater and press again to turn off the heater.
3. Press the "+" key to increase the set temperature by 1°C, press the "－" key to decrease the set
temperature by 1°C, and hold the "+" key or the "－" key for 3 seconds to increase or decrease the set
temperature continuously.
EN
1 – Heating symbol
2 – Wi-Fi
3 – Child lock
4 – Battery level
5 – Room temperature
6 – Setting temperature
7 – Temperature "+"
8 – On/Off
9 – Temperature "-"
" and "+" at the same time within five minutes to start
Publicidad
