Publicidad
Idiomas disponibles
Idiomas disponibles
1) Device name: edit the thermostat name.
2) Device information: to check the virtual ID etc. device information.
3) Share device: you can share the control of this thermostat to other mobile numbers/email
addresses if they have been registered in "Smart Life" APP.
4) Create Group: you can group different thermostats to control together.
5) FAQ & Feedback: to report any problems to the APP supplier.
6) Add to the home interface: you can turn on the heater directly on the home interface.
7) Check Device network: check the Wi-Fi connection status of device.
8) Check Update: Get latest firmware version.
9) Remove Device: remove thermostat from your APP.
3.3.4. Remarks
1. The heater only supports 2.4GHz network.
2. Red light means the heater is online, blue light means the heater is powering on.
3. If long press Wi-Fi reset button 5-10s or repeat powering on/off the heater 4 times by plug, internal
Wi-Fi connecting information will be cleared, you need to pair Wi-Fi again.
4. Thermostat disable switch ON means disabling thermostat.
5. Wi-Fi or network disconnected will cause heater offline and heater powering off.
6. The blue LED indicator may not light up at the first time when you finished the WIFI connecting, you
need to wait for a couple of seconds due to network searching and connecting.
7. Alkaline battery is recommended for the remote control. Please remove the battery if long time no
use.
8. If the remote cannot turn on the heater, please check if the setting temperature is not high above the
room temperature.
9. Put the remote controller at most 8 meters from the heater.
10. Do not mount the remote controller close to any cold or heat source.
11. Do not cover the remote controller.
12. Locate it in an open normal room environment rather not inside a drawer/pocket etc., or under
pillow/quilt etc.
13. Do not use heaters in wet or running water environment.
14. Please pull out the heater power supply from your socket if long time no use.
15. Both the remote-controller and App can turn on/off the heater and set the temperature. The remote-
controller setting can be linked to the App, but the App setting cannot be linked to the remote-
controller.
16. If the connection between remote and the built in receiver breaks and the temperature data can't be
received for 5 minutes, the APP will display --.-, and the heater will stop heating, meanwhile, the
mobile will get a warning message. If the connection is done again, the APP will display real room
temperature.
17. If the remote-controller is disconnected, please bring the remote-controller close to the heater (less
than 3 meters) and repair.
18. If the remote controller is always disconnected at one location, move it somewhere else.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
b)
Use only non-corrosive cleaners to clean the surface.
c)
After cleaning the device, all parts should be dried completely before using it again.
d)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
e)
Do not spray the device with a water jet or submerge it in water.
f)
Do not allow water to get inside the device through vents in the housing of the device.
g)
The device must be regularly inspected to check its technical efficiency and spot any damage.
h)
Use a soft cloth for cleaning.
i)
Do not leave the battery in the device if it will not be used for a longer period of time.
j)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
EN
Publicidad
