Publicidad
Idiomas disponibles
Idiomas disponibles
TO START/STOP MASSAGE ACTION
Before using, first read all of the instructions including the warnings and safety precautions as
well as the section on programmed and manual massage.
(BEGINNING OPERATION)
1. To operate the massage, push left side button.
O Check to be sure the operation indicator lamp is lit.
2. If you wish to stop the massage temporarily, push right side button.
The massage heads will stop where they are.
O Check to be sure the operation indicator goes out. To resume massage press left side button.
3. After final use, push the left side button to restore massage heads.
O The massage heads will go up, spread out and stop in the restore position. With the heads in this position
you can sit comfortably, using the massager as a regular chair.
O Be sure to store the controller in the pocket on the side of the left armrest when not in use.
4. Do you want programmed or manual operation?
IMPORTANT NOTE: If you have never had a massage, we suggest you start in the manual mode.
Olf you wish to select the programmed massage, move the slide
cover to lower position completely.
O If you wish to select the manual massage, move the slide cover
to upper position completely. (See NOTE)
NOTE: Be sure to check position of slide cover.
Edo coter
For manual operation, slide cover must depress the sensor
pin located at upper left of the stide track.
Automatic timer for massage lounger
O To prevent excessive massaging there is a built-in timer which after approx. 15 minutes of operation
will automatically turn the massage heads to the "restore" position and stop their motion.
O Turning on the operation switch while the massage heads are moving to the restore position will reset
the time for another 15 minutes (approximately).
O If the programmed massage button is pushed, the unit will stop after finishing the program.
Publicidad
