• Ratings
• Motors
• Container
• Cord
• cULus
GROUNDING INSTRUCTIONS
• For your protection, Waring
equipped with a 3-conductor cord set.
• 120 volt units are supplied with a molded 3-prong grounding-
type plug and should be used in combination with a properly
connected grounding-type outlet, as show in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained to enable a 2-slot wall outlet to be
used with a 3-prong plug.
Referring to Figure 3, the adapter must be grounded by
attaching its grounding lug under the screw of the outlet
cover plate.
CAUTION: Before using an adapter, it must be determined that
the outlet cover plate screw is properly grounded. If in doubt,
consult a licensed electrician.
Never use an adapter unless you are sure it is properly
grounded.
NOTE: Use of an adapter is not permitted in Canada.
BLENDER
ONE QUART CAPACITY SPECIFICATIONS
120 VAC- 50/60 Hz– single phase
Permanently lubricated series – wound
universal type
44 oz. polycarbonate or stainless steel
6-foot, 18-gauge, 3-conductor grounding cord
with strain relief
120 volt models
Commercial Blenders are
®
4