Publicidad
START UP
- Open the gas flow from the gas cylinder regulator.
- Press and turn the control knob to the "PILOT" position (90º counterclockwise).
- Press the control knob all the way down and hold it for about 60 seconds.
Then press the "Ignition" button while holding down the control knob until you hear a "click".
Repeat the operation until the pilot flame ignites.
Note.
If the gas cylinder has just been changed, keep the control knob pressed in the "pilot" position
for a few more seconds to bleed the circuit.
- Once the pilot flame is lit, wait a few seconds and release the control knob.
If the flame goes out, repeat the ignition process.
- After the pilot flame is lit, turn the control knob to the "maximum" position and wait about 5
minutes, then select the desired temperature.
TURN OFF THE STOVE
- Turn the control knob to the "pilot" position.
- Press and turn the control knob to the "Off" position.
- Close the gas cylinder regulator.
CLEANING AND MAINTENANCE
- Always clean with the stove off and totally cold.
- Clean dust from surfaces with a soft, dry cloth.
- Never use abrasive cleaning products or objects that damage the appliance.
- Cover the stove when it is not going to be used to free it from dust.
Publicidad
