Publicidad
5. Put the gas bottle in the housing and connect the regulator to it. Secure it to the
housing with the belt attached to the housing to prevent it from tipping over.
6. Leak test.
It has to be done before the first few, manually and when replacing a component in reference to
gas such as the hose or regulator.
Do not smoke while performing this test and remove all nearby sources of ignition.
Turn the burner knob to the OFF position.
Open the gas regulator valve.
With a solution of half and half soap and water, scrub all joints, regulator connections, hose,
controls and valves.
If bubbles appear it will be because there is a gas leak.
Tighten all connections well or change the part if it is in bad condition.
In the event that you cannot stop the gas leak, immediately close the gas valve and consult the
technical service.
Do not use the range until the gas leak has been fixed.
Publicidad
