Publicidad
Idiomas disponibles
Idiomas disponibles
3. DESCRIPTION OF COMPONENTS.
4. OPERATION.
- Place the rods to be used in the blender (mixers or kneading machines).
- Depending on the set of rods you are going to use, one of the two
a gear that has to be put on the same side of the gear
of the container.
- Put the mixture to beat or knead in the container.
- Anchor the blender to the rotating body.
- Press the release button (5) and lower the blender to the bowl until
the top and that is well anchored.
- Plug into the socket and select the desired speed.
- The container turns automatically while it is in operation.
- When the mix is ready select speed "0" and unplug.
- Press the release button (5) to raise the blender.
- Press the release button (4) to unpin the blender from the body.
- Press the "Eject" button to eject the rods.
1. "EJECT" BUTTON TO RELEASE
DIPSTICKS.
2. SPEED SELECTOR.
3. PUSHBUTTON TURBO.
4. RELEASE BUTTON TO REMOVE
THE MANUAL MIXER.
5. LIBERATION BUTTON
ROTATING CONTAINER.
6. BEATERS RODS.
7. KNEADER.
5. WARNINGS.
- BREACH THESE WARNINGS AND IGNORE THE
INSTRUCTIONS IN THIS MANUAL, EXEMPT THE MANUFACTURER OF
ALL RESPONSIBILITY FOR POSSIBLE FAILURES OR DAMAGES.
- BEFORE PLUGGING IN CURRENT, PUT IN ZERO SPEED.
- NEVER USE FOR MORE THAN 5 MINUTES FOLLOW.
MAXIMUM 2 CYCLES OF 5 MINUTES WITH 10 MINUTES REST.
THEN LEAVE COOLING THE ENGINE FROM 30 TO 60 MINUTES.
- DO NOT LEAVE WITHIN METALLIC OBJECTS, SPOONS, KNIVES, ETC.
- NEVER PRESS THE "EJECT" BUTTON (1) IN OPERATION.
- AVOID OVERFLOWS, CAN DAMAGE THE GEARS.
- UNPLUG OF THE CURRENT AFTER EACH USE.
6. CLEANING AND STORAGE.
- Make sure that the appliance is unplugged from the electric current.
- Let the appliance cool down before starting to clean it.
- Remove blender from the rotating body by pressing the release button(4).
- Remove the rods, by pressing the "EJECT" button.
- Clean the blender and rotating body with a damp and soft cloth.
- The container and the rods can be cleaned with soap and water.
- Never use abrasive or corrosive cleaning products.
- The rods and container can be put in the dishwasher.
- Dry with a soft absorbent cloth or with absorbent kitchen paper.
- Mount all the components.
- Wind the cable loosely avoiding tightness.
- Store in a cool and dry environmental place.
Publicidad
