iOttie Auto Sense 2 Fold Manual Del Usuario página 28

FCC Part 15 Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
: Changes or modifications not expressly approved by the party
CAUTION
responsible for compliance could void the user's authority to operate the product.
: This equipment has been tested and found to comply with the limits for
NOTE
a wireless power transfer, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Hereby, iOttie, Inc declares that the radio equipment type HLCRIO161 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration
of conformity is available at the following internet address: www.iottie.com.
Declaration for EU Compliance: Operation Freq: 118.59-151.12 kHz, Max.
RF power transmitted: H-Field 20.35dBμA/m @3m distance.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator and your body. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Operational Warnings
During the charging process, the transfer of electricity gives off heat. Your
device may become warm, but should not become exceedingly hot.
If the device gets wet, please cease charging immediately. Remove all
plugs and dry the product completely. Device is only to be operated in a
dry, indoor environment.
Please be careful of excessive drops, dents, punctures, or deformities on
the device. If you are concerned, please unplug the device and contact the
manufacturer.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate
the equipment.
Operating this device in a hot environment or in direct sunlight for a long
period of time may cause malfunctions. We recommend keeping the
product in cooler temperatures.
Please use included components for an optimal experience. To support
Qi wireless charge when using a third party car charger or a USB Power
Adapter use a minimum output of both "DC 9.0V-1.67A or DC z5.0V-2.0A"
and at least QC 2.0.
The product's signal could possibly interfere with you TPMS (tire pressure
monitoring system). If you notice that your TPMS light turns on, please try
using your mount in different locations to avoid the signals from interfering
with each other.
California Proposition 65 this product contains chemicals known to
the state of California to cause cancer and birth defects or other
reproductive harm.