iOttie Auto Sense 2 Fold Manual Del Usuario página 6

Using the Auto Sense Mechanism
Once it is unplugged or the car is turned off, the Auto Sense's
internal battery keeps a charge for up to one hour.
Mounting and Charging
1. Hold the phone in front of the
mount cradle to activate the
automatic clamping arms.
Releasing Device
Release buttons are located on
either side of the mount cradle. To
release your phone simple press
one or both buttons and the arms
will open. The release buttons can
also be used to open the mount
arms.
•
Note: The Auto Sense is powered via a USB-C cable and coil cell battery. There is
no on/off switch. Once it is plugged in, the device will remain on unless the vehicle
is turned off.
10 EN
2. Place the phone inside the mount.
The arms will close automatically
after one second and wireless
charging will begin.
Adjusting the Mount
Cradle Knob
To rotate the cradle, loosen the
cradle knob. Tighten to lock into
desired position.
Telescopic Arm
To extend the arm, loosen the
telescopic knob, move the arm
into the desired position, and then
tighten the knob again to secure
the arm in place.
Bottom Foot
The foot can be adjusted up and
down to fit any size phone by pulling
down or pushing up.
Pivot Knob
Turning the pivot knob allows you to
adjust the telescopic arm. Tighten to
secure the arm in place.
11