iOttie Auto Sense 2 Fold Manual Del Usuario página 5

02 Installation
Assembling the Mount
1. Connect the mount cradle to the
ball joint.
Attaching the Mount
Choose a flat location on the vehicle's dashboard and wipe any dust or
debris from the surface.
20
1
min
3
LOCK
2
• The dashboard pad is mounted with a semi-permanent adhesive tape.
Once removed, it cannot be re-mounted.
• When mounting, it is recommended that the surface and product be above 65F.
• When removing the dashboard pad, please use caution. We recommend removing
slowly from the edge to avoid damage.
Note: To reuse the suction cup, simply rinse under warm water and let air dry to restore
tacky suction.
8 EN
2. Tighten the cradle knob.
1. Peel off the film on the dashboard
pad and evenly press onto the desired
installation location. Wait at least 20
minutes before attaching the mount to
ensure a secure hold.
2. Remove the plastic cover from the
suction cup and firmly press the mount
onto the dashboard pad.
3. Push the locking lever down to
engage suction.
Connecting Power
1. Plug the included USB-C cable into the USB port located on the back of the
mount cradle.
2. Connect the USB-C cable to your vehicle's USB-C port or auxiliary power
outlet via a 20W adapter. (Power adapter not included.)
Note: If connecting directly to your vehicle's USB-C port, charging speeds
may be affected. For the fastest charge, we recommend connecting to the
auxiliary power outlet via a 20W adapter.
9