Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL MOUNTING BRACKET
1. Construct wood wall framing
that is flush
with interior surface of wall studs.
Make sure:
a) the framing is centered over installation
location.
b) the height of the framing will allow the
mounting
bracket to be secured to the
framing within the dimensions shown.
2. After wall surface
is finished
secure
mounting
bracket
to framing
using
dimensions
shown.
NOTE:
- On 8' ceilings,
the hood distance
above
cook top is :
minimum
24", maximum
28" (for Ducted
Configuration).
- On 9' ceilings,
the hood distance
above
cook top is :
- minimum 28", maximum 30" (the air vents
on the upper flue will be exposed
after installation).
INSTALL
FLUE
MOUNTING
BRACKET
DUCTED
1.Assemble
the flue
mounting
bracket,
adjusting outside width as shown.
Fig.5
2. Carefully
center
the mounting
bracket
directly over the range hood location.
3. Secure the bracket assembly to the ceiling
using (2) 4.8x38mm mounting screws and
drywall anchors. Make sure the bracket is
pushed into the corner, tight against the
wall and centered over the hood.
PREPARE THE HOOD
Note: On stainless steel hoods, carefully
remove the plastic protective film from all
exterior surfaces of the hood and decorative
flues, prior to final installation.
DUCTED
CONFIGURA
-lION
1. Install the discharge
collar into the duct
connector of the range hood. Fig .6
36
42
FRAMING BEHIND DRYWALL
/4"= bottom of hood 24" above ¢ooktop
/4"= bottom of hood 30" above ¢ooktop
fig.4
FLUE MOUNTING
BRACKET
f
/
(197mm)
........... _,
3.9 x 6ram
FLAT HEAD
BRACKET SCREWS
\
fig.5
6"
fig.6
6
Publicidad
