Solo 206 Eazy Manual Original página 14

7 Work preparation
Fig. 1:
a. Spray tank
b. Tank lid screwed to the filling socket (c)
d. Carry handle
e. Standing foot
f. On/off switch
g. Hand valve
h. Spray wand
i. Nozzle attachment
j. Spray tube holder
k. Carrying belt
l. Rechargeable battery
Outside of work, the spraying wand (h) is attached
to the spraying wand holder (j) in the handle (d).
7.1 Assembly
Assembly of the spraying wand (h):
Fig. 2:
 Start the cap nut (p) evenly and screw the spray
-
tube with the O ring (16x3 mm) onto the hand
valve (g) hand-tight without tools.
 Screw the nozzle attachment (i) onto the spray
tube hand-tight without tools.
Assembly carrying belt
Fig. 3:
 Attach the carrying belt to the side fastenings as
shown and adjust to the required length.
7.2 Filter, filling screen and intake screen
Fig. 2:
The nozzle assembly (i) includes a filter (q) insert
in front of the nozzle.
Fig. 4:
The basket in the filling neck (c) of the liquid tank
contains a filter screen(r).
Fig. 5:
The intake screen (s) is pushed on at the intake
manifold to the pump of the spraying agent tank.
The filter (q), filling screen(r) and intake screen (s)
are required when using the device.
7.3 Charging the battery
Before removing the rechargeable battery from the
device, always switch the on/off switch to "0"!
Fig. 6
To remove the rechargeable battery from the
device, compress the two latching levers (n) to
unlatch the battery, and then take out the battery
upwards.
The rechargeable battery needs to be charged
before you can use the pressure sprayer for the
first time.
ENGLISH 4
Charging time: Approx 2 hours
Place the charger on a stable support and connect
it to a suitable mains.
Before replacing the battery, make sure that the
battery and charger contacts are clean, dry, and
free of foreign bodies.
Fig. 7
Push the battery into the charger in the proper
position (according to the figure).
While the battery is charging, the LED on the
charger lights up red. Once the battery is fully
charged, the LED switches to green.
After charging, remove the battery from the charger
upwards and disconnect the charger from the
mains.
Fig. 8
Put the battery into the device in the correct
position (according to the figure) from above until it
latches noticeably. Check that the battery is seated
securely.
7.4 Test run
Before its initial use, the sprayer should be tested
according to chapter 10.2.
8 Preparing the spray liquid and filling the
spray tank
Prepare the spray liquid according to the
instructions of the chemical manufacturer.
Always prepare the spray liquid outdoors, never in
living quarters, stables or storage rooms for food
and animal feed.
To fill the spray tank, always remove the
rechargeable battery from the unit and close the
protective cover for the rechargeable battery
compartment.
When filling the spray tank, always use the filler
basket with the integrated filter screen (r).
Fig. 6
Fill the tank no further than to the upper-most mark
(MAX) of the spray tank.
Overfilling the tank or spills can contaminate public
waterways, rain- and storm water channel and
must be avoided.
Wipe off spilled spray liquid without delay.