Publicidad
Idiomas disponibles
Idiomas disponibles
TCS-NET Modbus Protocol Conversion Interface
1
Precautions for Safety
Manual readers
This manual and the Modbus Implementation Specification Manual are intended for readers shown below.
Those who have knowledge and qualification of electricity and control and are in charge of any of the following:
• Installation of the product
• Design of the control system
• Management of the site
Agreements for use of this product
(1) Scope of warranty
If a failure occurs in this product due to our fault or negligence, we will provide a replacement or repair the faulty
product. However, when the failure is caused by any of the following causes, we shall not be responsible for the
failure.
• The product was handled or used under conditions/environment that are not specified in this manual.
• The failure was caused by other causes than this product.
• The product was altered or repaired by persons other than Toshiba Carrier.
• The product was not used in accordance with its original purpose.
• The cause of the failure was not foreseeable with our scientific and technical levels at the time of shipping.
• The failure is due to a natural calamity, disaster, or the like.
The warranty mentioned here shall cover only this product, and any damage and losses resulting from the failure
of this product shall be excluded from the scope of warranty.
(2) Restrictions of liability
In no event shall we be liable for any special, indirect, or consequential damage arising out of or in connection with
the use of this product.
(3) Conditions for use of this product
• When this product is to be used in combination with other products, the dealer or qualified professional shall
check the applicable standards, specifications, laws, and regulations beforehand. The dealer or qualified
professional shall also verify that this product conforms to the customer's system, machines, and/or equipment
in which this product is to be used. If the dealer or qualified professional fails to do so, we shall not be responsible
for the conformity of this product.
• When you wish to use this product for any of the following purposes, be sure to consult our sales staff and use
this product with a margin of rating and performance, as well as take appropriate safety measures for safety
circuit, mechanism, etc. that will minimize danger in case of a failure.
* Use this product outdoors or for purposes that may cause latent chemical contamination or electrical interference
or use under conditions/environment that are not specified in this manual.
* Use this product in nuclear power control facilities, incineration facilities, railway/airline/vehicle facilities, medical
equipment, amusement machines, safety devices, and equipment/facilities that are restricted by administrative
organizations and/or respective industries.
* Use this product in systems, machines, or equipment that may pose a danger to human life or properties.
* Use this product in systems or facilities that require high reliability, such as gas/water/electricity supply systems
and non-stop operation systems.
* Use this product for other purposes that require a high level of safety.
• Thoroughly understand and strictly observe all prohibitions and precautions for use stated in this manual to
prevent contingent damage or losses to you or other persons due to improper use of this product.
(4) Changes to specifications
The specifications described in this manual and the contents of the Modbus Implementation Specification are
subject to change for improvement or other reasons without notice. Contact our sales staff to confirm the latest
specifications of this product.
– 3 –
Installation Manual
EN
2-EN
Publicidad
