Sony CDP-CE315 Manual De Instrucciones página 5

Getting Started
Hookups
When connecting an audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player Amplifier
©)
`Ü You can adjust the output level to the amplifier (CDP-
CE315 and CDP-C260Z only) |ï |
Press LINE OUT LEVEL +/- on the remote. You can
reduce the output level up to -20 dB.
When you reduce the output level, "ATT." appears in the
display.
When you turn off the player, the output level
automatically returns to the maximum level.
Note
If you press the LINE OUT LEVEL +/- buttons on the
remote while recording, the recording level will change
even when it is preset on the tape deck, etc.
* If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD (European models
only)
Connect the component via the DIGITAL QUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Note that you cannot use fading in or out (page 15) and
Time Fade (page 15) functions when making this
connection.
POC-15
Optical cable (not supplied)
CD player Digital component
DIGITAL DIGITAL
INPUT
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software other
than music, such as a CD-ROM.
Setting the voltage selector (voltage
selector equipped models only)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.
220 - 240 V
mov oo
==
Connecting the AC power cord
110-120 V
Connect the AC power cord to a wall outlet.
Transporting the player
Before transporting the player, follow the procedure
below to return the internal mechanisms back to their
original position.
1 Remove all the discs from the disc tray.
2 Press 8 OPEN/CLOSE to close the disc tray.
"no dISC" appears in the display.
3 Wait for 10 seconds, then press POWER to turn off
the player.
Sen