Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Loading edge cover
The loading edge cover (hereinafter cover) is designed for the FABIA (PJ3) )
vehicles with the basic luggage compartment floor. This can be used also for
FABIA (PJ3) vehicles with a variable loading floor, but it must be accepted
that the fastening part of the cover may be deformed due to contact with
the variable floor and that the variable floor itself will be slightly raised at the
cover.
The cover is designed to protect the loading edge of the rear bumper when
loading/unloading luggage into and out of the luggage compartment of the
vehicle, to protect people from contamination when handling luggage and to
sit on the loading edge.
CAUTION! The use of the cover may cause damage to the paint of the rear
bumper at the contact surface of the mat; therefore, it is necessary to
stick a protective foil from the ŠOP range on the rear bumper. Any damage
caused by not using a protective foil is not covered by the warranty.
CAUTION! The graphics marked on the bumper foil in no way replace the
portable warning triangle according to the relevant decree.
This instructions manual shows the use of the mat in the FABIA (PJ3) vehicles
with the basic floor.
The kit includes (Fig. 1)
Part name
Loading edge cover
Attachment bolt
Fitting instructions
• Raise the luggage compartment floor
• Cover fastening locations:
• FABIA (PJ3): The relevant places are already pre-marked on the trim (Fig. 3)
• To facilitate the screw assembly, it is possible to pre-prepare the holes with a
• Bend the relevant part of the cover fastening strap by 90° according to the
• Place the cover on the loading edge trim and fix it with screws in the marked
• Lower the floor to the basic position and attach the cover to the shopping bag
Transport position - the cover is hung in hooks using the loops (Fig. 4), or it
lays loose on the floor (Fig. 5).
Caution. Do not put your lagguage on the cover in the transport position,
there is a risk of damage to the cover.
Functional position – the cover is thrown over the loading edge. Release the
loops from the hooks and throw the cover over the loading edge and the rear
bumper (according to Fig. 6 and 7). To return to the transport position, use the
reverse procedure.
Qty
Position
Do not slide / rub over the bumper, in the case of a more dirty bumper, the
1
A
paintwork surface damage could occur. Before using the cover, it is necessary
2
B
to consider whether the bumper is not too dirty and whether dirt adhering to
it cannot damage the bumper or the cover.
Fitting the cover
suitable tool.
type of vehicle (Fig. 2, 3);
/ prepared places (B) – (Fig. 3). For FABIA (PJ3) vehicles, use the segment 4 on
the fastening part of the cover.
hooks using the loops (Fig. 4).
Instructions for use and maintenance of the cover
5
Publicidad
