General Information Regarding Unitest Cable Length Meters; Control Elements/Display Elements - BEHA UNITEST 3000 Manual De Instrucciones

4.0 General Information regarding
UNITEST Cable Length Meters
The UNITEST Cable Length Meters are measure-
ment instruments for swift, easy, and precise de-
termination of the lengths of a cable or a conductor.
Connect the instrument by means of the two alliga-
tor clamps (Kelvin clamps) supplied to both cable
or conductor end and set the respective measure-
ment range. The conductor length is clearly indi-
cated on the digital display.
The UNITEST Cable Length Meters enable the mea-
surement of the most conventional cable cross sec-
tions in copper or aluminium. Additionally, 84 freely
adjustable cable cross sections are available for
programming and measurement.
The built-in memory is used to save test results and
to transfer via interface to a PC.
5.0 Control Elements / Display Elements
Control Elements:
1. RS-232 interface
2. LCD
3. Function keys
4. Push-button On/Off/Start
5. Selection dial for the measurement ranges
6. Measurement input sockets
ERROR
TAB
T
M
REF CAL
General Information / Control Elements / Display Elements
1
ft
2
m
Ω
Cu Al
RES
3
4
5
6
Display Elements:
1. Emergency reflective triangle
2. Error display
3. Battery display
4. Measurement value
5. Measurement unit
6. Aluminium / copper display
7. Cumulative data memory (Res) display
8. Temperature compensation display
9. Table / reference range display
10. Memory display (M)
1 2
ERROR
TAB
M T
CAL
REF
10 9 8
3
4
ft
5
m
Ω
6
Cu Al
RES
7
21