Descargar Imprimir esta página

Craftsman 917.28852 Manual Del Operador página 19

Ocultar thumbs Ver también para 917.28852:

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Refill enginewith oilthrough oilfill d ipstick
tube. Pour slowly. Donot o verfill. For a p-
proximate capacity see"PRODUCT
SP-
ECIFICATIONS"
section o fthis manual.
7. Usegauge on oil fill cap/dipstick for
checking level.Foraccurate r eading,
tighten dipstick c apsecurely o ntothe
tube before r emoving dipstick. Keep o il
at"FULL' lineondipstick. Tighten c ap
onto thetube securely when f inished.
ENGINE OIL FILTER
Replace the engine oil filter every season or
every other oil change if the tractor is used
more than 100 hours in one year.
AIR FILTER
Your engine will not run properly using a
dirty air filter. Service paper cartridge every
100 hours of operation
or every season,
whichever occurs first.
Service air cleaner more often under dusty
conditions.
1. Remove cover.
2. Carefully remove air filter cartridge and
pre-cleaner from base.
3. Clean base carefully to prevent debris
from falling into carburetor.
Knobs
Ca_ridge
NOTE: If very dirty or damaged,
replace
cartridge.
4. Place new pre-cleaner
and cartridge
firmly in base.
5. Replace cover.
IMPORTANT:
Petroleum solvents, such as
kerosene, are not to be used to clean the
cartridge. They may cause deterioration
of
the cartridge.
Do not oil cartridge.
Do not
use pressurized air to clean cartridge.
CLEAN AiR SCREEN
Air screen must be kept free of dirt and chaff
to prevent engine damage from overheating.
Clean with a wire brush or compressed airto
remove dirt and stubborn dried gum fibers.
ENGINE COOLING SYSTEM
Debris may clog the engine's air cooling
system. Remove blower housing and clean
area shown to prevent
overheating
and
engine damage.
Clean out chaff
and debris
IN=LINE FUEL FILTER
The fuel filter should be replaced once each
season.
If fuel filter becomes clogged, ob-
structing fuel flowto carburetor, replacement
is required.
1. With engine cool, remove filter and plug
fuel line sections.
2. Place newfuetfilter
in position in fuel line
with arrow pointing towards carburetor.
3. Be sure there are no fuel line leaks and
clamps are properly positioned.
4. Immediately wipe up any spilled gasoline.
Clamp
Fuel Filt_
MUFFLER
inspect and replace corroded muffler and
spark arrester (if equipped) as it could create
a fire hazard and/or damage.
SPARK PLUG(S)
Replace spark plug(s) atthe beginning of each
mowing season or after every 100 hours of
operation, whichever occurs first. Spark plug
type and gap setting are shown in "PROD UCT
SPECIFICATIONS"
section of this manual.
19

Publicidad

loading