Craftsman 917.276910 Manual Del Operador página 10

6. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS - Position hole
in arm over pin (B) on outside of tractor
chassis and secure with washer and
retainer spring.
7. Repeat on opposite side of tractor.
10. Turn steering wheel to position wheels
straight forward.
11 .ATTACH FRONT LINK (E) - Work from
left side of tractor. Insert rod end of link
assembly through front hole in trac-
tor front suspension bracket (F) and
secure with retainer spring (G) through
hole in link located behind the bracket.
12. Insert other end of link (E)into hole in
front mower bracket (H) and secure
with washer and retainer spring (J).
8. ATTACH REAR LIFT LINKS (C) - Insert
rod end of link assembly into hole in trac-
tor lift shaft suspension arm (L) and pivot
link down to mower. Lift rear corner of
mower and position slot in link assembly
over pin on rear mower bracket (D) and
secure with washer and retainer spring.
9. Repeat on opposite side of tractor.
13. Disengage belt tension rod (K) from
locking bracket (L).
14. Install belt onto engine clutch pulley (M).
IMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves.
02937
10