Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART:
See appropriate
section in manual unless directed to Sears service center
PROBLEM
Will not start
Hard to start
Engine will not
turn over
Engine clicks but
will not start
CAUSE
1. Out of fuel.
2.
Engine
not "CHOKED"
properly.
3.
Engine
flooded.
4.
Bad spark plug.
5.
Weak or dead battery.
6.
Dirty air filter.
7.
Dirty fuel filter.
8
Water in fuel.
9.
Loose
or damaged
wiring.
10. Carburetor
out of adjustment.
11. Engine valves out of
adjustment.
1.
Dirty air filter.
2.
Bad spark plug.
3.
Weak or dead battery.
4.
Dirty fuel filter.
5.
Stale or dirty fuel.
6. Loose or damaged wiring.
7. Carburetor out of adjustment.
8. Engine valves out of
adjustment.
1. Clutch/brake
pedal
not
depressed.
2.
Attachment
clutch
is
engaged.
3.
Weak or dead battery.
4.
Blown fuse.
5.
Corroded
battery
terminals.
6.
Loose
or damaged
wiring.
7.
Faulty ignition
switch.
8.
Faulty solenoid
or starter.
9. Faulty operator presence
switch(es).
1. Weak or dead battery.
2.
Corroded
battery
terminals.
3.
Loose
or damaged
wiring.
4.
Faulty solenoid
or starter.
CORRECTION
1.
Fill fuel tank.
2.
See "TO START
ENGINE"
in Operation
section.
3.
Wait several
minutes
before
attempting
to start.
4.
Replace
spark plug.
5.
Recharge
or replace
battery.
6.
Clean/replace
air filter.
7.
Replace
fuel filter.
8.
Empty
fuel tank and
carburetor,
refill tank with
fresh gasoline
and replace
fuel filter.
9.
Check
all wiring.
10. See "To Adjust
Carburetor"
in Service
and Adjustments
section.
11. Contact
a Sears
or other
qualified
service
center.
1. Clean/replace
air filter.
2.
Replace
spark
plug.
3.
Recharge
or replace
battery.
4.
Replace
fuel filter.
5.
Empty fuel tank and refill tank
with fresh, clean gasoline.
6.
Check
all wiring.
7.
See "To Adjust
Carburetor"
in Service
and Adjustments
section.
8.
Contact
a Sears
or other
qualified
service
center.
1.
Depress
clutch/brake
pedal.
2.
Disengage
attachment
clutch.
3.
Recharge
or replace
battery.
4.
Replace
fuse.
5.
Clean
battery
terminals.
6.
Check
all wiring.
7.
Check/replace
ignition
switch.
8.
Check/replace
solenoid
or
starter.
9.
Contact
a Sears
or other
qualified
service
center.
1.
Recharge
or replace
battery.
2.
Clean
battery
terminals.
3.
Check
all wiring.
4.
Check/replace
solenoid
or
starter.
30
Publicidad
