Publicidad
Strong vibrations
during spinning
Check that:
— The machine has been properly levelled as described
in the paragraph «Positioning and levelling»
on page 34.
f
— the washing machine has not been put too close to
walls or forniture
— the internal oscillating unit has been unlocked as
described in the paragraph «Unpacking» on page 34.
Too much foam forms in the drum and it comes out of the drawer
Water on the floor
Check that:
;
— the detergent used is the right one for automatic
machines and not for washing by hand
— it has been used in the quantity indicated in this
booklet and not higher ones.
Check that:
— The connectors of the water supply pipe have not
come loose
— the end of the drain hose has not moved out of position.
The fabric conditioner is not fully introduced or too much water remains in the
compartment
Check that the siphons in the detergent dispenser are
properly positioned in their seat and are not clogged up.
Clean them as described in the paragraph «Cleaning the
detergent dispenser» on page 57.
The machine will not spin The anti-imbalance safety device has been tripped because
The laundry will not dry
Draining water from
the drum
60
the taundry is not evenly distribuited inside the drum.
If the laundry is still wet at the end of the program, you are
advised to rearrange it in the drum by hand and repeat the
spin program only.
Check that:
— the water tap is open
— the load of laundry is not too much
— drying time is sufficient.
If the machine does not still dry, call the after sales
service to clean possible fraying deposits, the fan and the
drying duct.
If there is a power failure or the washing-machine breaks
down, the water contained in the basket can be emptied
in an emergency proceeding as described in the
paragraph «Cleaning the drain pump» on pages 56 - 57 at
points 1-2-3-5.
©
Avertencia!
Al empezar la lectura de este manual abra las
páginas finales de ilustraciones.
Publicidad
