u
m
(3
i
Remote Control Unit Preparation
a
(Ly
G
Battery Installation (Inserting/Replacing the Batteries) | num battery
È
4 Remove the battery holder
(included)
a
Puli the holder by the position B while pushing position
Back side
A in the direction indicated by the arrow
2 Install the battery on the battery holder
Set a new battery properly with its (4-) side facing up as
shown in the figure
3 Insert the battery holder
Push in the battery holder back into its original position
Position B
Battery Notes
Remove and dispose of an old battery immediately
Battery Information
e Battery type Panasonic lithium battery (CR2025) (included)
e Battery life
Approximately 6 months with normal use (at room temperature)
Battery holder
Position À
Caution:
e Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire
Battery leakage may damage the unit
o Do not disassemble or short the battery Do not throw a battery into a fire
e Keep batteries away from children to avoid the risk of accidents
e Be careful to the local disposal rules when you dispose of batteries
Control Reference Guide
Point the remote control unit at the remote sensor
Power button (PUR)
———]1- (e)
(te)
Menu button (MENU)
(> page 12)
(> page 13)
(ay
Aspect button (ASPECT) —
A)
(= page 14)
JE ON
ob
eis buttons (A, V)
Bright button (BRIGHT)
QUE
pages 13, 15, 16)
(> page 15)
a
OM
Picture button (PICTURE)
—)-(P)
(> page 16)
Enter button (ENTER)
(= pages 13, 16)
Ca
M3838000
b
+%