AENO DB7 Guia De Inicio Rapido página 7

WARNING! The protective cover ensures that the micro-USB port is waterproof. If
the protective cover is removed, do not allow liquids to enter the port of the device.
Connect the device to a power source using a USB (A) / micro-USB cable. The
battery charge indicator will light up yellow. When the indicator turns green, the
battery is fully charged. Disconnect the device from the power source, and then
disconnect the cable from the micro-USB port. Insert the protective cover into the
device handle.
Choosing the Operation Modes of the Device
Turn on the device by pressing the power button once. Subsequent presses of the
button will switch the operating modes. The last used mode is saved in the device
settings the next time the device is turned on.
Operating Modes
 "Soft". Delicate, gentle brushing of the teeth. Recommended for brushing
sensitive teeth, as well as for brushing children's teeth.
 "Clean". Daily brushing. Recommended for standard brushing.
 "White". Teeth whitening. Recommended for people who smoke and drink tea
or coffee often.
Operation
With the head with bristles. Install the head as shown in fig. D. Wet the bristles
of the brush head and apply the desired amount of a dental care product to the
bristles. Point the bristles toward the surface of the teeth at an angle of about 45°.
Press the power button to turn on the device. Brush your teeth without putting
too much pressure on the enamel. Every 30 seconds, the device will notify you to
change the cleaning zone by briefly stopping the vibration. Change the cleaning
zone after each notification. After 2 minutes of operation, the device will turn off
automatically.
With plaque remover. Install the attachment as shown in fig. E. Point the metal
end of the attachment toward the tooth surface at an angle of about 45°. Press the
power button to turn on the device. Clean problem areas with gentle vertical
strokes.
WARNING! Do not apply excessive force when using the plaque remover. Careless
use of the attachment can cause oral trauma as well as damage tooth enamel.
Every 30 seconds, the device will notify you to change the cleaning zone by briefly
stopping the vibration. Change the cleaning zone after each notification. After
2 minutes of operation, the device will turn off automatically.
Note. Using a plaque remover cannot substitute professional oral hygiene at the
dentist.
Cleaning and Maintenance
WARNING! Do not clean the device until it has been turned off and disconnected
from the power source.
Rinse the device and accessories under running water. Then wipe dry.
Troubleshooting
1. The toothbrush does not turn on. Possible cause: the battery is discharged.
Solution: charge the device (charging time – at least 4 hours).
2. The device is connected to a power source but is not charging (the battery
charge indicator is not lit). Possible cause: the device has not been used for a
long time. Solution: connect the toothbrush to a power source and wait about
15 minutes. If the battery charge indicator does not light up, contact an
authorized service centre.
If you have any questions or difficulties in using the AENO™ device, please e-
mail support
aeno.com/service-and-warranty. The specialists will help you solve the
problem, and you will not have to waste time and effort visiting the store.
ASBISc reserves the right to modify the device and to make changes and additions to this
document without prior notice to users.
The warranty period and service life is 2 years from the date of retail sale of the device.
Manufacturer: ASBISc Enterprises PLC, Iapetou, 1, Agios Athanasios, 4101, Limassol, Cyprus.
Made in China. All trademarks and brands mentioned herein are the property of their
respective owners. The date of manufacture is indicated on the package.
Up-to-date information and a detailed description of the device, as well as connection
instructions, certificates, information on companies that accept quality claims and
warranties are available at aeno.com/documents.
aeno.com/documents
at support@aeno.com or chat with us online at
7