GE 15 Serie Manual Del Propietario E Instalación página 17

Installation Instructions
[] PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
[] START THE ICEMAKER
On power switch models, set the icemaker power
switch to the I (On)position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin m operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically.
Power s witchmodel
Feeler A rmin the
STSP(up}position
_: F eeler Armin
the ON {down}position
Feelerarmmodel
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
IFJI REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swdng:
• Read the instructions all the w-ay through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Proxdde a non-scratching work surfhce for
the doors.
IMPORTANT: Once you begin, do not move tile
cabinet undl door-swing reversal is completed.
These instructions are for changing tile hinges fl'om
tile right side to the left side--if you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
TOOLS REQUIRED
Phillipsscrewdriver
5/16" hex-head
socketdriver
Puttyknife or thin-blade
screwdriver
Maskingtape
T20or T25Torxdriver,
(neededfor some
models}
5/16" open-end
wrench
17