GE 15 Serie Manual Del Propietario E Instalación página 20

Installation Instructions
IRI REVERSING THE DOOR SWING (CONT.)
[] REVERSING THE HARDWARE
4.1 Remove the base grille (if your refrigerator has
one) by pulling it straight out.
4.2 Move the bottom hinge bracket (and shim glued
to it) and plastic washer from the right side to the
left side.
Plastic
Plastic _ I Washer
Washer J'_----! _/,
Bracket Hinge _ -_
Bracket
Models with a hingebracket
that has 2 screw holes.
Modelswith a hingebracket
that has4 screw holes.
Switchthe hingepin to the
oppositeside ofthe bracket.
4.3 Interchange hinge (and the shim glued to it) and
screws at top right with screws at top left of cabinet.
Do not tighten screws on hinge side at this time.
Installingthe hingeon the left. Installingthe hingeon the right.
NOTES:
• Some hinges have four holes. Which holes you
use for installing the hinge depends on which
side you install the hinge.
• The outer edge of the hinge should be parallel
to the edge of the case for correct installation.
[] REVERSING THE DOOR HANDLES
5.1 Transfer fresh food door handle
5.1.1 Remove tile handle plug using a
tape-tipped putty knife under the edge,
and remove the screw underneath.
Remove tile two screws holding the
handle to the top of the dool:
/
Plug _
I
I
5.1.2 Remove the handle.
5.1.3 Remove the screws from the right edge of the
door top and insert them into the handle screw
holes on the opposite side.
5.1.4 With tape-tipped putty knite or thin-blade
screwdrivm; pry out the plug button from the
hinge hole on the left side of the door and
insert it into the hole on the opposite side that
was vacated by removal of the top hinge.
2O